Ametek CW Series Programming Manual Instrukcja Użytkownika Pobierz pdf (Strona 14)

Elgar CW-P Series SCPI Commands

Programming Manual 3-5

:STORe?

Return the present EEPROM register

address that was read to set the present

setpoint/register values. CW shall read in

EEPROM address 0 at power-up.

:RECall <value>

Specify that CW shall read in the EEPROM

setpoint/registers from EEPROM location

<value>.

:ERRor?

Return the last Error logged by the GPIB/

RS-232 command processor. If there are no

errors, CW shall return as SPACE.

:EXTernal

External connectors sub-tree.

:CLOCk?

Return the present state of the Clock/Lock

connector interface circuit.

:CLOCk <description>

„IN‟ sets the Clock/Lock connector interface to

an input, „OUT‟ makes the pin an output. See

Operation Manual for the pinout of connectors.

:LOCK?

Returns 1 if the Phase Lock Loop is in the

acquired (locked) state.

:ANAIN <boolean>

„1‟ (ON) specifies that the CW amplifiers will

slew 0 through programmed value in relation

to a 0-5 volt control signal. See Operation

Manual for connector pinouts.

:ANAIN?

Returns „1‟ if ANAIN is enabled.

:SERIALNO?

Returns the serial number.

:VER[S][ion]?

Return the code version of the FLASH

application presently active in the CW.

3.7 Master/Slave Commands

:SLAVECONFIG <description>

Accepts A0A0,A0A1,A0A2,A0A3,A0A4,A0A5,

A0B0,A0B1,A0B2,A0B3,A0B4,A0B5,A0C0,

A0C1,A0C2,A0C3,A0C4,A0C5.

See Operation Manual for usage of these

master/slave configuration options.

:SLAVECONFIG?

Returns A0A0,A0A1,A0A2,A0A3,A0A4,A0A5,

A0B0,A0B1,A0B2,A0B3,A0B4,A0B5,A0C0,

A0C1,A0C2,A0C3,A0C4,A0C5.

:SLAVEADDR <value>

Accepts 0-5. See Operation Manual for usage.

:SLAVEADDR?

Returns 0-5.

:SLAVECHAN <value>

Accepts A,B,C. See Operation Manual for usage.

:SLAVECHAN?

Returns A-C.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 24 25

Komentarze do niniejszej Instrukcji

Brak uwag