Ametek SFA Series Programming Manual Instrukcja Użytkownika Strona 37
- Strona / 48
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
SECTION 4
CALIBRATION
WARNING
Please refer to the power supply manual for further information before performing
calibration procedures. Calibration must be performed by qualified personnel who
appropriately deal with attendant hazards. If calibration is not performed properly,
functional problems could arise, requiring that the supply be returned to the
factory.
4.1 Introduction
The DIA is calibrated to adjust internal signal levels to correspond to the expected supply output
signal levels. You must perform the calibration procedures if the power supply’s programming
or readback performance falls out of specification due to component aging drifts. Refer to your
power supply manual to find the required calibration interval. The DIA is calibrated for output
current programming, output overcurrent protection programming, voltage readback, and
current readback. There are 10 calibration factors (four measurement and six output).
The calibration procedures in the following sections are designed to be performed at ambient
temperature of 25°C +
5°C, after the unit has had a stable output and a stable load for at least
30 minutes.
The following test equipment is required in addition to the computer system to complete the
following calibration:
•
6-digit digital voltmeter (DVM)
•
current shunt rated for 110% of full output current
4.2 Setup for Calibration
STEP DESCRIPTION
1. Disconnect the power supply’s AC input power.
2. Disconnect the load from the power supply you want to calibrate.
M550292-03 (Programming) 4-1
- SF Series 1
- SAFETY NOTICE 3
- CONTENTS 5
- SECTION 4 6
- SECTION 5 6
- FEATURES, FUNCTIONS 7
- AND SPECIFICATIONS 7
- 1.3 Specifications 8
- CONFIGURATION 9
- 2.2.1 Remote/Local Selection 10
- Shield Ground 11
- Address Selection 11
- IEEE 488.2 AND SCPI 13
- COMMAND OPERATION 13
- Error/Event Queue 15
- Serial Poll Operation 18
- Parameter Definitions 18
- 3.3.2 Units 19
- 3.3.3 Conventions 19
- 3.3.4 Queries 19
- SOURCE SCPI Command Summary 21
- MEASURE SCPI Command Summary 24
- OUTPUT SCPI Command Summary 26
- STATUS SCPI Command Summary 27
- SYSTEM SCPI Command Summary 29
- TRIGGER SCPI Command Summary 31
- CALIBRATION 37
- SCPI STATUS IMPLEMENTATION 43
Powiązane produkty i podręczniki dla Ekwipunek Ametek SFA Series Programming Manual
Ekwipunek Ametek ReFlex Instrukcja Użytkownika
(359 strony)
(359 strony)
Ekwipunek Ametek SGI Series Instrukcja Użytkownika
(128 strony)
(128 strony)
Ekwipunek Ametek SLM-1 Instrukcja Użytkownika
(77 strony)
(77 strony)
Ekwipunek Ametek SLM-4 Instrukcja Użytkownika
(77 strony)
(77 strony)
(185 strony)Cary Audio Design MS-1 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Systemy kina domowego Cary Audio Design MS-1.
Dostarczamy 1 pdf podręczników Cary Audio Design MS-1 do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Komentarze do niniejszej Instrukcji