Ametek ReFlex Programming Manual Instrukcja Użytkownika Pobierz pdf (Strona 94)

ReFlex Power™ Programming Manual AC Module Remote Programming

90 M380056-03 Rev L

• Programmable configuration: stand alone, parallel or phase group

EADBACK

UNCTIONS

• Measure voltage, current, frequency, and phase

• Voltage, current and frequency settings (phase, if in a phase group)

• Soft voltage and current limits

• Over/Under Voltage and Over Current protection setting

• Status and Accumulated Status registers

• Programming error codes

• Fault codes

• Manufacturer, power supply model, serial number, and firmware

version identification

4.3

POWER-ON CONDITIONS

Table 4-1 presents remote power-on conditions for the AC Power Supply.

Table 4-1. Remote Power-On Conditions

Condition Default

Voltage 0 Volts (initial power–on voltage). Also see CAL<n>:INIT:VOLT

Current 7.140 Amps (initial power–on current). Also see CAL<n>:INIT:CURR

Frequency 60 Hz

OVP Trip Voltage

154 V (110% of Module Maximum Voltage, which is 140 V) +7% (initial power–

on OVP). See CAL<n>:INIT:VOLT:PROT

Output OFF

Parallel No Modules Paralleled

Voltage Range Low

Phase 0.0 degrees, stand alone mode

OCP Trip Current

7.42 A (Maximum current 102% of the full scale current, which is 7 A for low

voltage range)

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 133 134

Brak uwag

Ametek ReFlex Programming Manual Instrukcja Użytkownika Strona 94