Ametek BPS Series Programming Manual Instrukcja Użytkownika Pobierz pdf (Strona 101)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power

Manual P/N 7003-961 Rev. AA 101

PONSetup:CURRent

This command sets the initial current limit at the power on. The maximum allowable current

is controlled by the voltage range and voltage mode.

Command Syntax [SOURce:]PONSetup:CURRent <NRf+>

Parameters range set by the LIMit:CURRent, voltage mode and voltage range

Examples PONS:CURR 22

Query Syntax PONS:CURR?

Returned Parameters <NR2>

PONSetup:FREQuency

This command sets the initial frequency of the power source at the power on.

Command Syntax [SOURce:]PONSetup:FREQuncy <NRf+>

Parameters set by the LIMit:FREQuency

Examples PONS:FREQ 50

Query Syntax PONS:FREQ?

Returned Parameters <NR2>

PONSetup:NOUTput

This command sets the configuration of the power source to one phase or three phase if this

option is enabled. The LAST setting causes the unit to power up in the mode it was left.

Command Syntax [SOURce:]PONSetup:NOUTput <selection>

Parameters ONEPhase|THReephase|LAST

Examples PONS:NOUT LAST

Query Syntax PONS:NOUT?

Returned Parameters <CRD>

PONSetup:OLOad[:MODE]

This command determines how the power source will react to an over current condition. In

const current mode, the output voltage is reduced to a value that maintains a constant laod

current. In constant voltage mode, the output faults to an initial value if the over current

condition is maintained beyond the protection delay period.

Command Syntax [SOURce:]PONSetup:OLOad[:MODE] <mode>

Parameters CCURrent|CVOLyage

Examples OLOad CCUR

Query Syntax PONS:OLO?

Returned Parameters <CRD>

Related Commands CURR:PROT:STAT

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 225 226

Brak uwag

Ametek BPS Series Programming Manual Instrukcja Użytkownika Strona 101