Ametek BPS Series Programming Manual Instrukcja Użytkownika Pobierz pdf (Strona 15)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power

Manual P/N 7003-961 Rev. AA 15

2.2.2 Types of SCPI Messages

There are two types of SCPI messages, program and response.

• A program message consists of one or more properly formatted SCPI commands sent

from the controller to the AC/DC source. The message, which may be sent at any time,

requests the AC/DC source to perform some action.

• A response message consists of data in a specific SCPI format sent from the AC source

to the controller. The AC source sends the message only when commanded by a

program message called a "query."

2.2.3

The SCPI Command Tree

As previously explained, the basic SCPI communication method involves sending one or

more properly formatted commands from the SCPI command tree to the instrument as

program messages. The following figure shows a portion of a subsystem command tree,

from which you access the commands located along the various paths (you can see the

complete tree in appendix A).

Root

:OUTPut

:PON

:TTLTrg

:IMPedance

:OPERation

:SOURce

:REAL

:REACtive

:STATus

[:STATe]

[:EVEN]?

:CONDition?

Figure 2-1 : Partial Command Tree

The Root Level

Note the location of the ROOT node at the top of the tree. Commands at the root level are

at the top level of the command tree. The SCPI interface is at this location when:

• The AC/DC source is powered on

• A device clear (DCL) is sent to the AC source

• The SCPI interface encounters a message terminator

• The SCPI interface encounters a root specifier

Active Header Path

In order to properly traverse the command tree, you must understand the concept of the

active header path. When the AC/DC source is turned on (or under any of the other

conditions listed above), the active path is at the root. That means the SCPI interface is

ready to accept any command at the root level, such as SOURCe or MEASurement

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 225 226

Komentarze do niniejszej Instrukcji

Brak uwag

Ametek BPS Series Programming Manual Instrukcja Użytkownika Strona 15

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Ametek BPS Series Programming Manual