Ametek BPS Series Programming Manual Instrukcja Użytkownika Pobierz pdf (Strona 137)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power

Manual P/N 7003-961 Rev. AA 137

5.9 *RST

The reset (*RST) command has the same effect as an IEEE-488 Device Clear bus

command but can be used over the RS232C interface as well. This command resets the AC

source to the following factory-defined states:

Table 5-1 : *RST default parameter values

Item Value Item Value

INIT:CONT OFF [SOUR:]LIST:STEP AUTO

OUT OFF [SOUR:]PHAS:MODE FIX

OUTP:TTLT OFF

OUTP:TTLT:SOUR BOT

[SOUR:]CURR:PROT:DEL 100ms [SOUR:]VOLT:TRIG

[SOUR:]FREQ:MODE FIX [SOUR:]VOLT:SLEW:MODE FIX

[SOUR:]FREQ:SLEW MAX [SOUR:]VOLT:SLEW:TRIG MAX

[SOUR:]FREQ:SLEW:MODE FIX TRIG:CONN NONE

[SOUR:]FREQ:SLEW:TRIG MAX

[SOUR:]FREQ:TRIG 60Hz TRIG:SYNC:SOUR IMM

[SOUR:]FUNC:MODE FIX TRIG:SYNC:PHAS 0

TRIG:SOUR IMM

Command Syntax *RST

Parameters None

Related Commands *SAV

A *RST command or a IEEE-488 Device Clear also clears all status registers but does not

change the Event Enable registers for each status register group.

Application note:

When using the *RST command on systems set to power up in single phase mode, it will be

necessary to momentarily change the power on selection to three phase mode to ensure all

three phases are re-initialized. This can be done with the following code sequence:

PONS:NOUT? // Determine current PONS phase setting.

PONS:NOUT THR // Set to three phase initialization

*RST // Issue reset commend.

Delay 500msec // allow time to reset system.

If <response> <> THR Then // Set back if needed

PONS:NOUT <response>

End if

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 225 226

Brak uwag

Ametek BPS Series Programming Manual Instrukcja Użytkownika Strona 137