Ametek Lx Series II Programming Manual Instrukcja Użytkownika Pobierz pdf (Strona 198)

Programming Manual Lx \ Ls Series II

194

DO160:ABNormal:FREQuency:TRANsient

This command applies to Group 1 only for the EuroCAE standard. Refer to the User Manual for

details.

Command Syntax DO160:ABNormal:FREQuency:TRANsient

Parameters none

Examples DO160:ABN:FREQ:TRAN

Query Syntax none

Returned Parameters none

8.4.5 DO160 Test Setup Commands

DO160:STANdard

This command will select the proper test standard. The standard selection must be set prior to

any test selection.

The RTCA2 selection includes the Change 2 notice to the DO160D test standard as it applies to

section 16. The RTCA selection does not include the Change 2 updates.

The Airbus standard is the same as the EuroCAE-14D standard with the exception of nominal

voltage modulation.

Command Syntax DO160:STANdard

Parameters RTCA | RTCA2 | EURocae | AIRBus

Examples DO160:STAN RTCA

Query Syntax DO160:STAN?

DO160:GROup

This command is used to select equipment Group 1, 2 or 3 for the EUROCAE standard or

equipment Group ACF, ANF or AWF for the RTCA2 standard. Some test (commands) apply only

to specific groups of equipment. If a test is executed for a group to which it does not apply, the

command is ignored by the power source. Note that in this case no error is generated. The

application program is responsible for selecting the relevant Standard, Group and test.

Command Syntax DO160:GROup <NR1>

Parameters 1 | 2 | 3 | ACF | ANF | AWF

Examples DO160:GROup 2

Query Syntax DO160:GRO?

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 241 242

Brak uwag

Ametek Lx Series II Programming Manual Instrukcja Użytkownika Strona 198